Ikan CVM-WM100 | Comica Wireless Lavalier Microphone Kit

Ikan CVM-WM100 Comica Wireless Lavalier Microphone Kit

The CVM-WM100 is a wireless lavalier microphone kit from CoMica. This kit contains one transmitter, one receiver, one lavalier microphone with a 3.5mm connector, a soft case, and accessories like a wind muff, 3.5mm-XLR adapter, and cold shoe mounts for the transmitter and receiver.

To use this kit, install two AA batteries in both the transmitter and receiver, then turn them on. Select one of 48 available channels, and monitor for signal interference. If there is a lot of interference on one channel, scan through others until you find a clean, noise-free channel to use. Both the transmitter and receiver can be worn on the belt, mounted to the included cold shoe mounts, or attached to an accessory arm via the 1/4-20 mounting point on each unit.

When a solid signal is established, connect the lavalier mic and, if you desire, a secondary sound input device to the transmitter. Plug the receiver into the camera, recorder, or speaker of your choice (for speakers, make sure they have sufficient amplification to adequately handle the signal). Test the levels by taking test-audio, and get to recording! When recording is finished, the entire kit can be placed into the included soft carrying case for storage and transport.

Key Features

• 100m maximum transmission distance
• 48 channels to choose from between 520-534.1MHz
• Less than .5% audio distortion
• Receiver and transmitter run on 2 AA batteries (not included)
• 3.5mm input/output ports with 3-pin XLR adapter included
• Mounts with included belt clips or via 1/4-20 mounting points on TX/RX bodies
• LCD screen includes signal strength and battery life indicators

Technical Specifications

Antenna Type
>65db
Audio Distortion
<0.5%
Battery Type
2x AA (not included)
Channels
48
Frequency Range
520-534.1MHz
Inputs
3.5mm
Max Range
100m
Outputs
3.5mm
Receiving Sensitivity
-95dBm
Sound Delay
<20ms
Stray Radiation
< -60dBc
Transmitting Power
10mw/30mw