Teradek Beam Transmitter and Receiver Set, V Mount Transmitter and V Mount Receiver

SKU: TRD-100582 Category:
Brand: Teradek


The Teradek Beam Transmitter Receiver set comes with 1 Beam Transmitter and 1 Beam Receiver in an SKB Case.

Beam is multicast capable to an unlimited number of Rx over LAN and to up to 4 receivers over WiFi.
This set contains 1 Receiver but please consider purchasing additional Beam Receivers.

Technical Specifications

Beam TX – AB Mount
Video Inputs
Sdi Compliance
SMPTE 259M BI.656: SDTV Digital Signal/Data Serial Digital Interface
SMPTE 292M BT.1120: 1.5Gb/s Signal/Data Serial Digital Interface
SMPTE 425M: 3Gb/s Signal/Data Serial Digital Interface
SMPTE 299M: 16bit Digital Audio Format for SMPTE 292M
SMPTE 352M: Video Payload Identification for Digital Interfaces
Video Outputs
Looping 3G/HD/SD-SDI: BNC
Delay Tx To Rx
90-110 milliseconds
Supported Resolutions
576i50 (PAL)
480i59.94 (NTSC)/480i60 (861-D)
Video Compression
H.264 Baseline Profile Level
4.2 with De-Interlacing
Supported Video Bitrate
RTSP Server – Up to 30Mbps
MPEG2-TS Server – Up to 15Mbps
Color Correction
Audio Input
Main Digital Audio In
SDI embedded audio: 48kHz 16-bit stereo linear PCM
Talk Back Analog Audio In
8kHz 16-bit stereo linear PCM with mini stereo phone input/output jack
Audio Output
Main Digital Audio Out
SDI embedded audio: 48kHz 16-bit stereo linear PCM
6.7" x 4.1" x 1.1" (170 x 105 x 28 mm)
34.92oz (990g)
Feature-rich WebUI for configuration and control
Configuration Interfaces
OLED Display with joystick Navigation buttons
On/Off and Reset Switch
External Control
Full duplex RS422 serial port
10/100 BASE-TX, RJ-45 jack
WiFi:IEEE 802.11a/n: OFDM
Frequencies – U-NII-1 (5.15-5.25 GHz), U-NII-3 (5.725-5.85 GHz)
Wireless Protected Setup for easy set up and security configuration
Factory Reset
IP configuration or firmware upgrade without PC
802.1x, 802,11i, WPA2, WPA and WEP 64/128 TKIP 128bit AES
Rf Power
Aggregate Power: 150mW (22dBm), 50mW (17dBm)/antenna
Radio Standard – IEEE 802.11a/n: OFDM
Antenna – 3T x 3R MIMO, 3 antennas per WiMi6200TW/W1Mi6200RW
2500 ft+-200 ft
Unicast Multicast
WiFi: Up to 4 Receivers
LAN: No limit on number of receivers
Power Input
7V-17V DC
Nominal Power Consumption
12 W
Operating Temperature
0 ~ 50 deg-C

What’s In The Box?
1 x Beam Transmitter with a V Mount plate
1 x Beam Receiver with a V Mount plate1 x Protective SKB Case – military-standard waterproof hard case with custom foam
1 x 110-240V AC Power Adapter
3 x Transmitter Antennas
3 x Receiver Antennas
1 x Lightstand Adapter 1/4 20"
1 x Thumb Screw
1 x Quickstart Guide
1 x BNC Cable 10inch
1 x 1-Year Warranty

SKU: TRD-100582 Category:

Based on 0 reviews

0.0 overall

Be the first to review “Teradek Beam Transmitter and Receiver Set, V Mount Transmitter and V Mount Receiver”

There are no reviews yet.